Compressor

The compressor increases the pressure of the gaseous refrigerant. This raises its temperature to a usable level.

1234
How a heat pump works: the refrigerant cycle
  1. Evaporator: the cold refrigerant absorbs heat from the air, ground or water and evaporates.
  2. Compressor: it compresses the vapour, which increases the temperature. Electricity is needed here.
  3. Condenser: the hot vapour releases its heat to the heating water and becomes liquid again.
  4. Expansion valve: the pressure drops, the refrigerant cools down, and the cycle starts all over again.
Schematic. Blue is the cold side, orange the warm side of the cycle.

The compressor is the component that 'pumps' heat to a higher temperature level. It draws in the gaseous refrigerant from the evaporator and brings it to a higher pressure. This also increases the temperature until it is sufficient for heating. The hot gas then flows into the condenser. As a rule, an electric motor drives the compressor. According to the Umweltbundesamt (Federal Environment Agency), gas engines and thermal compressors are still rare.

Why this is important

The greater the difference between the heat source and flow temperature, the more compression energy the system requires and the lower the seasonal coefficient of performance (SCOP) becomes. Control also matters. Modulating heat pumps adjust their heating output to demand via the compressor. According to the klimaaktiv Wegweiser (guide), they are significantly more efficient than fixed-speed units that can only switch on and off.

What this means for you

  • Ask in the quote whether the unit operates in a modulating way.
  • Have the heating load calculated rather than estimated. According to klimaaktiv, an oversized system negatively affects lifespan and efficiency.
  • Lower the flow temperature wherever possible. Reducing it by 5 °C improves the seasonal coefficient of performance by around 10 to 15%, according to the guide.
  • Have a separate electricity meter fitted for the compressor and auxiliary drives if one is not integrated.

You can read about how output control works under Inverter. What happens with oversized units is explained in the entry on Short cycling.

All terms · Heat pump knowledge