Condenser
In the condenser, the hot refrigerant gas transfers its heat to the heating water, turning back into a liquid in the process.
- Evaporator: the cold refrigerant absorbs heat from the air, ground or water and evaporates.
- Compressor: it compresses the vapour, which increases the temperature. Electricity is needed here.
- Condenser: the hot vapour releases its heat to the heating water and becomes liquid again.
- Expansion valve: the pressure drops, the refrigerant cools down, and the cycle starts all over again.
The condenser is the heat exchanger on the heating side. This is where the hot gas from the compressor arrives. It transfers its heat to the heating water, condensing in the process and becoming liquid again. The same thing happens in a fridge on the fins at the back, except that the heat ends up in the room as waste heat.
Why this is important
The heat that the condenser needs to supply to the heating system is determined by the flow temperature. The higher it is, the more electricity the heat pump requires. According to the klimaaktiv guide, lowering it by 5 °C improves the seasonal performance factor (SPF) by around 10 to 15 %. If a storage tank is connected in between, its charging temperature is a few degrees above the flow temperature of the heating circuit, according to Energieinstitut Vorarlberg.
What this means for you
- Have the heating curve set low enough so that the rooms are just warm enough.
- Have hydraulic balancing carried out.
- If a storage tank is necessary, its temperature should be as close as possible to the required flow temperature, according to klimaaktiv.
- A heat meter shows you how much heat actually reaches the heating system.
You can read about how to lower the temperature in an existing building under Flow temperature. What happens next in the cycle is shown by the expansion valve.
Related terms
Sources
- Umweltbundesamt (Deutschland): Umgebungswärme und Wärmepumpen (accessed on 4 November 2026)
- klimaaktiv Guide to Good Heat Pump Installation (2026) (accessed on 4 November 2026)
- Energieinstitut Vorarlberg: Die Wärmepumpe, eine Glanzleistung an Effizienz (accessed on 4 November 2026)